The Advantage
VoIP technology uses the Internet's packet-switching capabilities to provide phone service. VoIP has several advantages over circuit switching. For example, packet switching allows several telephone calls to occupy the amount of space occupied by only one in a circuit-switched network. Using PSTN, that 10-minute phone call we talked about earlier consumed 10 full minutes of transmission time at a cost of 128 Kbps. With VoIP, that same call may have occupied only 3.5 minutes of transmission time at a cost of 64 Kbps, leaving another 64 Kbps free for that 3.5 minutes, plus an additional 128 Kbps for the remaining 6.5 minutes. Based on this simple estimate, another three or four calls could easily fit into the space used by a single call under the conventional system. And this example doesn't even factor in the use of data compression, which further reduces the size of each call.

Let's say that you and your friend both have service through a VoIP provider. You both have your analog phones hooked up to the service-provided ATAs. Let's take another look at that typical telephone call, but this time using VoIP over a packet-switched network:

1. You pick up the receiver, which sends a signal to the ATA.

2. The ATA receives the signal and sends a dial tone. This lets you know that you have a connection to the Internet.

3. You dial the phone number of the party you wish to talk to. The tones are converted by the ATA into digital data and temporarily stored.

   VoIP TermsThe central call processor is a piece of hardware running a specialized database/mapping program called a soft switch. See the "Soft Switches" section to learn more.

4. The phone number data is sent in the form of a request to your VoIP company's call processor. The call processor checks it to ensure that it is in a valid format.

5. The call processor determines to whom to map the phone number. In mapping, the phone number is translated to an IP address (more on this later). The soft switch connects the two devices on either end of the call. On the other end, a signal is sent to your friend's ATA, telling it to ask the connected phone to ring.

6. Once your friend picks up the phone, a session is established between your computer and your friend's computer. This means that each system knows to expect packets of data from the other system. In the middle, the normal Internet infrastructure handles the call as if it were e-mail or a Web page. Each system must use the same protocol to communicate. The systems implement two channels, one for each direction, as part of the session.

7. You talk for a period of time. During the conversation, your system and your friend's system transmit packets back and forth when there is data to be sent. The ATAs at each end translate these packets as they are received and convert them to the analog audio signal that you hear. Your ATA also keeps the circuit open between itself and your analog phone while it forwards packets to and from the IP host at the other end.

8. You finish talking and hang up the receiver.

9. When you hang up, the circuit is closed between your phone and the ATA.

10. The ATA sends a signal to the soft switch connecting the call, terminating the session. Probably one of the most compelling advantages of packet switching is that data networks already understand the technology. By migrating to this technology, telephone networks immediately gain the ability to communicate the way computers do.

It will still be at least a decade before communications companies can make the full switch over to VoIP. As with all emerging technologies, there are certain hurdles that have to be overcome.